Karaoke Forums

I have a powered JBL G2 and was wondering if Im able to loop out to any other powered speaker or just another JBL G2? Im assuming it just sends a signal and should be able to connect to any powered speaker. Thanks, Bob

Put it in the loop mode and you can drive any balanced input . The input to the speaker is routed to an isolation amp so in the loop mode there is no impedance difference. The output only sees the input.

In the mix mode the xlr is switched to mic in and mixed with the 2 1/4 inch inputs.

Right now we are daisy chaining another speaker to the bar area.

_________________
Join The Karaokle Singers Social Network. Upload Your Music!!

You assume correct. A simple mic cable will connect the two.

Now matching from an *audio* aspect is another story. There are reasons we run speakers in matched pairs....

_________________
[color=#ffff55]Mickey J.[/color]
Alas for those who never sing, but die with all their music in them.
-- Oliver Wendell Holmes, Sr.

I have a big Karaoke contest that we are running in a pretty large bar. I was looking to put 2 bose sticks near the stage and running 4 JBL EON G2's (2 on each side) down the sides. I would go from mixer to sub to Eons to bose sticks.

Personally I would run the Bose sticks as monitors off the monitor feed, boosting and cutting the vocal volume as required to suit the singer.

_________________
[color=#ffff55]Mickey J.[/color]
Alas for those who never sing, but die with all their music in them.
-- Oliver Wendell Holmes, Sr.

Was thinking about doing that but I dont see any monitor out on my Mackie CFX 12 Mixer.

Aux 1 & 2 on the channels are both set up to be monitor sends.

_________________
LIKE Lonman on Facebook - Lonman Productions Karaoke & my main site via my profile!