| Karaoke Scene's Karaoke Forums https://mail.karaokescenemagazine.net/forums/ |
|
| Round out my system https://mail.karaokescenemagazine.net/forums/viewtopic.php?f=1&t=18852 |
Page 1 of 1 |
| Author: | fromadistance [ Sun Jan 10, 2010 2:06 pm ] |
| Post subject: | Round out my system |
Well so far i have the following A&H Zed 12 FX Mixer Dbx 266 XL Yamaha P5000S Dual Channel Power Amp BBE 882I SONIC MAXIMIZER 2 Yamaha Br 15 speakers Couple SM 58 mics Been thinking about adding a Yamaha SW118V Sub down the road. What else besides the sub could i add to round out my system? Would i see any benefit with a dual channel 31 band EQ? |
|
| Author: | lyquiddye [ Mon Jan 11, 2010 5:34 am ] |
| Post subject: | Re: Round out my system |
You purchased a really nice mixer and amplifer and speakers I wouldn't use as end tables. The BR series speakers are just terrible. I would look at a better set of speakers. |
|
| Author: | letitrip [ Mon Jan 11, 2010 6:48 am ] |
| Post subject: | Re: Round out my system |
Well if you've got money burning a hole in your pocket, here are some suggestions on what you could add to your rig (besides subs which you've already mentioned). * A vocal monitor for the stage (would be my top priority if I were you) * A mono 31-Band EQ for the stage monitor * A 2-Channel 31-Band EQ for the main mix * A good outboard multi-effects processor (Higher end Lexicon or T.C. Electronic) * An outboard delay unit (T.C. Electronic D-Two would be the dream unit here) * If you use "fill" music between singers, get a second compressor with side-chain input and use it for ducking |
|
| Author: | jeffsw6 [ Mon Jan 11, 2010 2:04 pm ] |
| Post subject: | Re: Round out my system |
I like the Lexicon MX400 fx processor, which has pretty good reverbs and also has good delays and a tap-tempo button. This is the only FX unit I need for bar-bands and karaoke because it is very easy to use one set of I/O for both reverb and delay on vocals, and the other I/O to fatten up an acoustic guitar or drum. I send it two auxes and bring the signals back to the board on 4 channel strips. |
|
| Page 1 of 1 | All times are UTC - 8 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|