micbob @ Sat May 02, 2009 10:30 am wrote:
Will be using a set of JBL PRX525 powered speakers and want to know if I would connect from my mixer to the speaker the same way you would if using JBL EON G2's. Actually what Im looking to do is go from my mixer to processor to JBL PRX speakers loop out to JBL EONS. Will this work? We tried this briefly months back and the PRX tops were popping in and out we think it was a power issue with the venue we were at. I just want to make sure this speakers dont require a special connection setup which if not properly connect cause the popping. Thanks
What kind of processor are you going through.
The G2 has an output connection on it, you want to make sure the LOOP/MIX button is not engaged (out). This will send only the signal to the output that the input is being fed. If it is engaged, it will send any adjustments on the speakers own eq/mixer settings - which could cause the popping on the PRX if it was connected after the G2.
Otherwise you can put the PRX first then output to the G2 & it should work fine - the output is just a tap off of the input.